Operation CHARM: Car repair manuals for everyone.
Home >> Chevrolet >> 1998 >> Monte Carlo V6-3.8L VIN K >> Repair and Diagnosis >> Cruise Control >> Brake Switch (Cruise Control) >> Service and Repair >> Cruise Control Release Switch and Stoplamp Switch Adjustment
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Cruise Control Release Switch and Stoplamp Switch Adjustment

Cruise Control Release Switch And Stoplamp Switch Adjustment (Typical):




The cruise control release switch and the stoplamp switch are adjusted together. Incorrect adjustment could cause the cruise control system to not work properly.

Adjust
1. Remove LH I/P insulator panel.
2. Depress brake pedal fully.
3. Push switch(es) into retainer(s) until fully seated.
4. Pull brake pedal fully rearward against pedal stop until audible clicks can no longer be heard.

Measure
^ The following brake pedal travel distances can be used to validate proper cruise control release switch and stoplamp switch adjustment.
- Cruise control release switch and stoplamp switch contacts must be open at 3.5 to 12.5 mm (1/8 to 1/2 inch) of brake pedal travel, measured at the centerline of the brake pedal pad. Nominal actuation of the stoplamp switch contacts is about 4.5 mm (3/16 inch) after cruise control switch contacts close.

5. Install LH 1/P insulator panel.
pro multis · About Operation CHARM