Manual Transmission - M5 and MJ1

Removal Procedure





1. Disconnect the vehicle speed sensor (VSS) lead from the transaxle.
2. Remove the VSS bolt.
3. Remove the VSS retainer.





4. Remove the VSS assembly.
5. Remove the O-ring.

Installation Procedure
1. Lubricate a new O-ring with synchromesh transaxle fluid GM P/N 12345349 or equivalent.
2. Install the new O-ring.
3. Install the vehicle speed sensor (VSS) assembly.





4. Install the VSS retainer.
5. Install the VSS bolt.
^ Tighten the bolt to 9 Nm (80 inch lbs.).
Refer to Fastener Notice in Service Precautions.





6. Connect the VSS lead to the transaxle.