Export

REMOVAL PROCEDURE




1. Disconnect the license lamp electrical connector.
2. Remove the rear license lamp screws.
3. Remove the rear license lamp from the rear fascia.




4. Remove the rear license lamp bulbs (2), if necessary.

INSTALLATION PROCEDURE




1. install the rear license lamp bulbs (2), if necessary.




2. Install the rear license lamp to the rear fascia.

NOTE: Refer to Fastener Notice in Service Precautions.

3. install the rear license lamp screws.

Tighten
Tighten the rear license lamp screws to 1.9 N.m (17 lb in).

4. Connect the license lamp electrical connector.