Operation CHARM: Car repair manuals for everyone.
Home >> Chevrolet >> 2000 >> Camaro V8-5.7L VIN G >> Repair and Diagnosis >> Powertrain Management >> Ignition System >> Crankshaft Position Sensor >> Service and Repair
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Crankshaft Position Sensor: Service and Repair

REMOVAL PROCEDURE

IMPORTANT: The PCM Idle Learn Procedure must be performed whenever the battery is disconnected. Refer to CKP System Variation Learn Procedure. Perform the CKP System Variation Learn Procedure when the Crankshaft Position sensor is removed or replaced.




1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
2. Remove the starter.




3. Disconnect the Crankshaft Position (CKP) sensor electrical connector.




4. Remove the CKP sensor retaining bolt.
5. Remove the CKP sensor.

INSTALLATION PROCEDURE




1. Install the CKP sensor.

NOTE: Refer to Fastener Notice in Service Precautions.

2. Install the CKP sensor retaining bolt.

Tighten
Tighten the CKP sensor to 25 N.m (18 lb ft).




3. Connect the CKP sensor electrical connector.




4. Install the starter.
5. Lower the vehicle.
6. Perform the CKP System Variation Learn Procedure. Refer to CKP System Variation Learn Procedure.
7. Perform the Idle Learn Procedure. Refer to PCM Idle Learn Procedure. Programming and Relearning
pro multis · About Operation CHARM