Multifunction, Turn Signal & Hazard Switch

Removal Procedure

Caution: Refer to Battery Disconnect Caution in Service Precautions.





1. Disconnect the negative battery cable.

Caution: Refer to SIR Handling Caution in Service Precautions.

2. Disable the Supplemental Inflatable Restraint (SIR). Refer to Disabling the SIR System in Air Bags and Seat Belts.
3. Remove the steering wheel. Refer to Steering Wheel Replacement.
4. Remove the steering column trim covers. Refer to Steering Column Trim Cover Replacement - On Vehicle.
5. Remove the 2 Torso head screws from the multifunction switch (2).





6. Disconnect the electrical connectors from the multifunction switch (2).
7. Remove the multifunction switch (2) from the steering column.

Installation Procedure

1. Install the multifunction switch (2) to the steering column while depressing the spring loaded horn pin.
2. Connect the electrical connectors to the multifunction switch (2).

Notice: Refer to Fastener Notice in Service Precautions.

3. Install the 2 Torx head screws to the multifunction switch (2).
Tighten the screws to 4 Nm (36 inch lbs.).
4. Install the steering column trim covers. Refer to Steering Column Trim Cover Replacement - On Vehicle.
5. Install the steering wheel. Refer to Steering Wheel Replacement.
6. Enable the SIR system. Refer to Enabling the SIR System in Air Bags and Seat Belts
7. Connect the negative battery cable.
8. Ensure that the multifunction switch functions properly.