Accumulator: Service and Repair

Removal Procedure





1. Remove the 3rd and 4th clutch accumulator housing bolts (53).
2. Remove the 3rd and 4th clutch accumulator housing (51).
3. Remove the accumulator housing gasket (47). The accumulator housing gasket may be stuck to the spacer plate (46).
4. Remove the 3rd clutch accumulator piston spring (50).
5. Remove the 4th clutch accumulator piston spring (49).
6. Remove the control valve body spacer plate (46).
7. Remove the control valve assembly to spacer plate gasket (45) from the spacer plate (46).

Installation Procedure

^ Tools Required
- J 25025-5 Guide Pin





1. Install the J 25025 into the control valve body bolt hole where the manual shaft detent roller and spring assembly is mounted.
2. Install the control valve body gasket (45).
3. Install the control valve body spacer plate (46).





4. Install the third and fourth clutch accumulator housing gasket (47).
5. Install the third clutch accumulator piston spring (50). This spring is the longer of the two springs.
6. Install the fourth clutch accumulator piston spring (49).
7. Install the third and fourth clutch accumulator housing assembly (51) onto the control valve body assembly (44).
8. Install the six accumulator housing bolts (53). Start the bolts finger tight and work towards the opposite end.





Notice: Refer to Fastener Notice in Service Precautions.

9. Tighten the accumulator housing bolts sequentially.
^ Tighten the accumulator housing bolts sequentially to 11 Nm (97 inch lbs.).
10. Remove the J 25025-5.