TP Sensor Output

This check should be performed when TP sensor attaching pans have been replaced. A scan tool can be used to read the TP signal output voltage.
1. Connect the DMM from TP sensor connector terminal B (BLK wire) to terminal C (DK Blue wire). Jumpers for terminal access can be made using terminals 1214836 and 12014837
2. With ignition ON, engine OFF, the TP signal voltage should be less than 1.25 volts if more than 1.25 volts verity free throttle movement. If still more than 1.25 V, replace TP sensor.
3. Remove the voltmeter and jumpers, reconnect the TP sensor connector to the sensor.