Operation CHARM: Car repair manuals for everyone.
Home >> Chevrolet >> 2000 >> Impala V6-3.4L VIN E >> Repair and Diagnosis >> Engine, Cooling and Exhaust >> Engine >> Cylinder Head Assembly >> Rocker Arm Assembly >> Service and Repair >> Procedures
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Procedures

Valve Rocker Arm and Push Rod Replacement

- Tools Required
- J36660-A Torque Angle Meter

Removal Procedure





1. Remove the valve rocker covers.

Important: Keep the components separated in order to install the components in the same location.

2. Remove the rocker arm bolts.
3. Remove the rocker arms.

Important: Keep the pushrods in order in order to install the pushrods in the original position.

4. Remove the pushrods.

Installation Procedure





1. Install the pushrods in the original location.
- Coat the ends of the pushrods with GM P/N 1052356 or the equivalent.
- The intake pushrods are identified with yellow stripes and are 5 3/4 inches long.
- Exhaust pushrods are identified with green stripes and are 6 inches long.
- Ensure that the pushrods seat in the lifter.

2. Install the rocker arms.

Notice: Refer to Fastener Notice in Service Precautions.

3. Install the rocker arm bolts. See TSB 02-06-01-034
Tighten the rocker arm bolts to 14 Nm (124 inch lbs.). Use the J36660-A in order to tighten the bolts an additional 30 degrees.
4. Install the valve rocker covers.
pro multis · About Operation CHARM