Operation CHARM: Car repair manuals for everyone.
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Inflatable Restraint Side Impact Sensor Replacement

INFLATABLE RESTRAINT SIDE IMPACT SENSOR REPLACEMENT

REMOVAL PROCEDURE
1. Disable the SIR system. Refer to Disabling the SIR System.
2. Remove the center pillar lower trim.
3. Remove the Connector Position Assurance (CPA) from the inflatable restraint side impact sensor yellow 2-way harness connector.
4. Disconnect the inflatable restraint side impact sensor wiring harness connector.






5. Loosen the two inflatable restraint side impact sensor fasteners (2).
6. Remove the inflatable restraint side impact sensor (1) from the center pillar (3).

INSTALLATION PROCEDURE
1. Install the inflatable restraint side impact sensor (1) to the center pillar (3).
2. Tighten the two inflatable restraint side impact sensor (1) fasteners (2).
3. Connect the inflatable restraint side impact sensor yellow 2-way harness connector.

NOTE: Refer to Fastener Notice in Service Precautions.

4. Install the CPA to the inflatable restraint side impact sensor yellow 2-way connector.

Tighten
Use only hand tools to tighten the fasteners to 10 N.m (89 lb in).

5. Install the center pillar lower trim.
6. Enable the SIR system. Refer to Enabling the SIR System.