Automatic Transmission Range Selector Cable Bracket Replacement

Removal Procedure





1. Remove the throttle body air inlet duct. Refer to Powertrain Management.
2. Remove the automatic transaxle range selector cable from the automatic transaxle range selector [ever.





3. Remove the clip then release the cable from the range selector cable bracket.





4. Remove the automatic transaxle range selector cable bracket bolts.
5. Remove the automatic transaxle range selector cable bracket from the automatic transaxle.

Installation Procedure





1. Install the automatic transaxle range selector cable bracket to the automatic transaxle.

Notice: Refer to Fastener Notice in Service Precautions.

2. Install the automatic transaxle range selector cable bracket bolts.
- Tighten the automatic transaxle range selector cable bracket bolts to 25 Nm (18 ft. lbs.).





3. Install the automatic transaxle range selector cable to the bracket.
4. Install the retaining clip.





5. Install the automatic transaxle range selector cable to the automatic transaxle range selector lever.
6. Adjust the automatic transaxle range selector cable if necessary. Refer to Automatic Transmission Range Selector Cable Adjustment
7. Install the throttle body air inlet duct. Refer to Powertrain Management.