Scan Tool Testing and Procedures

Diagnostic Chart (Part 1 Of 2):

Diagnostic Chart (Part 2 Of 2):

CIRCUIT DESCRIPTION
There should always be a Malfunction Indicator Lamp (MIL) when the ignition is ON and the engine is OFF. Battery ignition voltage is supplied to the lamp. The PCM will turn the lamp ON by grounding the ignition feed circuit.

TEST DESCRIPTION
The numbers below refer to the step numbers on the diagnostic table.
2. This step verifies if the problem is in the scan tool or the vehicle.
6. This step will check the ground circuits at the DLC connector.
9. The step will check for the battery and ignition feeds to the PCM.