Endgate Strut Replacement

Endgate Strut Replacement

Removal Procedure

1. Open and support the endgate.

Notice: Refer to Liftgate/Hood Assist Rod Notice in Service Precautions.




2. Lift up the retainer clips on the endgate struts using a small flat-bladed tool.
3. Remove the upper end of the endgate struts from the ball joint.
4. Remove the lower end of the endgate struts from the ball joint.
5. Remove the endgate struts from the endgate.

Installation Procedure

1. Position the endgate struts to the endgate.




2. Install the upper end of the endgate struts to the ball joint. Press in to place until fully seated.
3. Install the lower end of the endgate struts to the ball joint. Press in to place until fully seated.
4. Remove the support from the endgate.
5. Close the endgate.