Knock Sensor 2 Replacement
Knock Sensor 2 Replacement
Removal Procedure
1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle Service and Repair.
2. Remove the wiring harness connector from the knock sensor (2).
Diagram:
3. Remove the knock sensor (2) from the engine block (1).
Installation Procedure
Diagram:
Notice: Refer to Fastener Notice .
1. Install the knock sensor (2) into the engine block (1).
Tighten the knock sensor to 19 Nm (14 lb ft).
2. Connect the harness connector to the knock sensor (2).