Oil Pressure Sensor: Service and Repair

ENGINE OIL PRESSURE SENSOR OR SWITCH REPLACEMENT

TOOLS REQUIRED
J 41712 Oil Pressure Switch Socket

REMOVAL PROCEDURE




1. Remove the engine cover from the vehicle. Refer to Engine Cover Replacement in Interior Trim.
2. Remove the electrical connector from the engine oil pressure (EOP) sending unit.
3. Use the J 41712 in order to remove the EOP sending unit from the engine block.

INSTALLATION PROCEDURE

NOTE: Refer to Component Fastener Tightening Notice in Service Precautions.

1. Use the J 41712 in order to install the EOP sending unit to the engine block.

Tighten
Tighten the oil sending unit to 12 N.m (9 lb ft).




2. Connect the electrical connector to the EOP sending unit.
3. Install the engine cover in the vehicle. Refer to Engine Cover Replacement in Interior Trim.