Automatic Transmission - 4 Speed-MS7
Vehicle Speed Sensor (VSS) Replacement^ Tools Required
- J36850 Transmission Assembly Lubricant
Removal Procedure
Caution: Refer to Battery Disconnect Caution in Service Precautions.
1. Disconnect the negative (-) battery cable.
2. Disconnect the Vehicle Speed Sensor (VSS) electrical connector.
3. Remove the 1 retaining bolt (1) and the VSS (2) from the transaxle.
4. Inspect the VSS O-ring for cuts or damage. Replace as necessary.
Installation Procedure
1. Apply J36850 to the VSS O-ring.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the Vehicle Speed Sensor (VSS) into the transaxle case. Secure the VSS (2) with the retaining bolt (1).
Tighten the VSS speed sensor (VSS) bolt to 6 Nm (53 inch lbs.).
3. Connect the VSS electrical connector.
4. Connect the negative (-) battery cable.