Alarm Module: Service and Repair
THEFT DETERRENT CONTROL MODULE REPLACEMENTREMOVAL PROCEDURE
1. Disable the SIR. Refer to Disabling the SIR System in Restraint Systems.
2. Remove the steering column trim covers.
3. Remove the ignition lock cylinder.
4. Remove the theft deterrent control module wiring harness from the steering column harness.
5. Disconnect the electrical connector from the theft deterrent control module.
6. If, necessary, disconnect the electrical connector from the ignition lock cylinder case.
7. Remove the theft deterrent module (2) away from the lock cylinder housing (1).
INSTALLATION PROCEDURE
1. Install the theft deterrent control module (2), onto the lock cylinder housing (1).
2. Install the theft deterrent control module wiring harness to the steering column harness.
3. If, necessary, disconnect the electrical connector from the ignition lock cylinder case.
4. Connect the electrical connector.
5. Install the ignition lock cylinder.
6. Install the steering column trim covers.
7. Enable the SIR system. Refer to Enabling the SIR System in Restraint Systems.
8. Program the new theft deterrent control module. Refer to Programming Theft Deterrent System Components. Programming and Relearning