Operation CHARM: Car repair manuals for everyone.
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

General Information

TOOLS REQUIRED
J41413 EVAP Pressure/Purge Diagnostic Station

INSPECTION PROCEDURE

NOTE: Use the EVAP Pressure/Purge Diagnostic Station J 41413 in order to provide a clean, dry, low pressure gas source. Do not substitute any other pressurized gas source. Damage may result to the EVAP system.

IMPORTANT: Do not perform this procedure unless instructed by an evaporative emission (EVAP) diagnostic.

1. Turn OFF the ignition.
2. Remove the EVAP canister purge valve.
3. Lightly tap the EVAP canister purge valve on a clean hard surface.
4. Inspect for carbon particles exiting either of the vacuum ports.
^ If no carbon particles are found, reinstall the EVAP canister purge valve and continue with the EVAP cleaning procedure.
^ If carbon particles are found during the inspection procedure, continue with the EVAP cleaning procedure.
^ If you were instructed to replace the EVAP canister purge valve, and no carbon particles are found, return to the EVAP diagnostic procedure. Do not perform the EVAP cleaning procedure.