Rear Door Window Regulator: Service and Repair
WINDOW REGULATOR MOTOR REPLACEMENT - REAR DOORREMOVAL PROCEDURE
1. Raise the window.
If the window motor is inoperable, remove the window to gain access to the window motor retaining screws.
2. Remove the door trim panel.
3. Remove the water deflector.
4. Remove the door speaker.
5. Support the window.
6. Disconnect the wiring harness from the window regulator motor.
7. Remove the 3 bolts from the window motor located on the front side of the motor.
8. Separate the motor from the cable housing by wiggling the window motor.
Observe the orientation of the window motor.
IMPORTANT: Do not allow the cable gear come out of the housing. A failure will result with the cable coming off the spool.
9. Remove the motor from the window regulator assembly.
INSTALLATION PROCEDURE
1. Install the motor to the cable housing by wiggling motor into place.
2. Install the 3 bolts to the window motor.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten
Tighten the bolts to 5 N.m (44 lb in).
3. Install the window, if removed.
4. Connect the wiring harness to the window regulator motor.
5. Remove the window support.
6. Connect the wire connector to the switch to inspect the operation of the window.
7. Install the speaker.
8. Install the water deflector.
9. Install the door trim panel.