Backup Lamp Switch: Service and Repair

Backup Lamp Switch Replacement

Removal Procedure

Notice: When removing or installing the backup lamp switch, do not use an open end wrench. Use only a socket in order to avoid damage to the switch assembly.





1. Disconnect the backup lamp connector.





2. Remove the backup light switch assembly.

Installation Procedure

Notice: When removing or installing the backup lamp switch, do not use an open end wrench. Use only a socket in order to avoid damage to the switch assembly. Refer to Fastener Notice in Service Precautions.





1. Install the backup light switch using pipe sealant GM P/N 1052080 or equivalent.
Tighten the switch to 33 Nm (24 ft. lbs.).





2. Connect the backup lamp connector.