Operation CHARM: Car repair manuals for everyone.
Home >> Chevrolet >> 2003 >> Cavalier L4-2.2L VIN F >> Repair and Diagnosis >> Restraints and Safety Systems >> Air Bag Systems >> Impact Sensor >> Service and Repair >> Inflatable Restraint Side Impact Sensor Replacement (Sedan)
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Inflatable Restraint Side Impact Sensor Replacement (Sedan)

REMOVAL PROCEDURE




1. Disable the SIR system. Refer to SIR Disabling and Enabling Zone 9 , or SIR Disabling and Enabling Zone 7.

CAUTION: Do not strike or jolt the inflatable restraint side impact sensor (SIS). Before applying power to the SIS make sure that it is securely fastened. Failure to observe the correct installation procedures could cause SIR deployment, personal injury, or unnecessary SIR system repairs.

2. Remove the center pillar upper trim.
3. Loosen the bolts (2) on the inflatable restraint side impact sensor.
4. Remove the inflatable restraint side impact sensor from the center pillar (1).




5. Remove the connector position assurance (CPA) (3) from the side impact sensor connector (4).
6. Disconnect the side impact sensor connector (4).

INSTALLATION PROCEDURE




1. Connect the side impact sensor connector (4).
2. Install the CPA (3) to the side impact sensor connector (4).




3. Remove any dirt, grease, or other impurities from the mounting surface.
4. Install the side impact sensor to the center pillar (1).
5. Align the locating pin on the sensor to the opening in the center pillar (1).
Begin tightening the side impact sensor bolts (2).

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten
Tighten the fasteners to 10 N.m (89 lb in).

6. Install the center pillar upper trim.
7. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 9 , or SIR Disabling and Enabling Zone 7.
pro multis · About Operation CHARM