Weatherstrip Retainer Replacement

Weatherstrip Retainer Replacement

Removal Procedure




1. Remove the push-in retainer securing the lower end of the weatherstrip to the lock pillar.
2. Remove the door opening weatherstrip from the lock pillar retainer
3. Remove the door opening weatherstrip from the roof retainer from the lock pillar to the windshield.




4. Remove the screws securing the lock pillar retainer.
5. Remove the lock pillar retainer.

Installation Procedure

Notice: Refer to Fastener Notice in Service Precautions.




1. Install the lock pillar retainer.

Tighten the lock pillar weatherstrip retainer screws to 3 N.m (27 lb in).

2. Apply a 6 mm (0.25 in) x 100 mm (4 in) bead of sealer across the lower edge of the retainer and onto the lock pillar.
3. Install the weatherstrip.