Operation CHARM: Car repair manuals for everyone.
Home >> Chevrolet >> 2003 >> S10/T10 P/U 2WD L4-2.2L VIN 4 >> Repair and Diagnosis >> Brakes and Traction Control >> Disc Brake System >> Service and Repair >> Disc Brake Hardware Replacement - Front (Single Piston)
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Disc Brake Hardware Replacement - Front (Single Piston)

Disc Brake Hardware Replacement - Front (Single Piston)

Removal Procedure
1. Raise the vehicle. Refer to Vehicle Lifting.
2. Remove the tire and wheel assembly.





3. Remove the brake caliper.
4. Remove the front brake pads.
5. Remove the front disc brake inner pad retainer spring.





6. Remove the following parts from the brake caliper.
^ Front brake caliper bolt
^ Front brake caliper bolt sleeve
^ Front brake caliper bolt sleeve bushing

7. Lightly brush all brake pad contact areas.

Installation Procedure
1. Clean area using denatured alcohol.





2. Dry area using non lubricated, filtered compressed air.
3. Apply high temperature silicone brake lubricant to the brake caliper pin bolts and retainers. DO NOT apply lubricant to the brake pad hardware.





4. Install the following parts on the brake caliper.
^ Front brake caliper bolt
^ Front brake caliper bolt sleeve
^ Front brake caliper bolt sleeve bushing





5. Install the inner brake pad retainer spring.
6. Install the brake pad to the brake caliper bracket.
7. Install the tire and wheel assembly.
8. Lower the vehicle. Refer to Vehicle Lifting.
9. With the engine running, firmly pump the brake pedal three times.
pro multis · About Operation CHARM