Operation CHARM: Car repair manuals for everyone.
Home >> Chevrolet >> 2003 >> S10/T10 P/U 2WD L4-2.2L VIN 4 >> Repair and Diagnosis >> Wiper and Washer Systems >> Wiper Motor >> Service and Repair
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Wiper Motor: Service and Repair

WIPER MOTOR REPLACEMENT

TOOLS REQUIRED
- J 39232 Wiper Transmission Separator
- J 39529 Wiper Transmission Installer

REMOVAL PROCEDURE




1. Remove the wiper arms.
2. Remove the air inlet grille panel.
3. Remove the transmission from the wiper motor drive link using the J 39232.




4. Disconnect the electrical connector from the wiper motor.
5. Remove the three screws and wiper motor from the vehicle.

INSTALLATION PROCEDURE

NOTE: Refer to Fastener Notice in Service Precautions.




1. Install the wiper motor onto the vehicle with three screws.

Tighten
Tighten the wiper motor mounting screws to 6.5 N.m (57 lb in).

2. Connect the electrical connector.

IMPORTANT:
- Lubricate the socket with white lithium grease (GM P/N 9985885) or equivalent.
- The wiper transmission must be assembled to the crank arm past the second detent so the seal is compressed to a maximum height of 25.5 mm (1 in).




1. Install the transmission drive link socket onto the crank arm ball of the wiper motor using the J 39529.
2. Install the air inlet grille panel.
3. Install the wiper arms.
pro multis · About Operation CHARM