Operation CHARM: Car repair manuals for everyone.
Home >> Chevrolet >> 2003 >> S10/T10 P/U 2WD L4-2.2L VIN H >> Repair and Diagnosis >> Brakes and Traction Control >> Disc Brake System >> Service and Repair >> Disc Brake Hardware Replacement - Rear
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Disc Brake Hardware Replacement - Rear

Disc Brake Hardware Replacement - Rear

Removal Procedure





1. Remove the disc brake caliper.





2. Remove the disc brake pads.
3. Remove the disc brake pad retainers.





4. Remove the caliper pins (5) from the disc brake caliper mounting bracket (3).
5. Remove the caliper pin boots (4) from the disc brake caliper mounting bracket.
6. Lightly wire brush all brake pad contact areas in order to remove any corrosion.

Installation Procedure





1. Install the caliper pin boots (4) to the disc brake caliper mounting bracket.
2. Install the caliper pins (5) to the disc brake caliper mounting bracket (3).





3. Install the disc brake pad retainers
4. Install the disc brake pads.





5. Install the brake caliper assembly.
6. With the engine OFF, gradually apply the brake pedal to approximately 2/3 of its travel distance.
7. Slowly release the brake pedal.
8. Wait 15 seconds, then repeat steps 7-8 until a firm brake pedal is obtained. This will properly seat the brake caliper pistons and brake pads.
9. Fill the brake master cylinder to the proper level.
pro multis · About Operation CHARM