Operation CHARM: Car repair manuals for everyone.
Home >> Chevrolet >> 2003 >> Venture V6-3.4L VIN E >> Repair and Diagnosis >> Powertrain Management >> Computers and Control Systems >> Crankshaft Position Sensor >> Service and Repair >> Crankshaft Position (CKP) Sensor Replacement (Sensor B)
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Crankshaft Position (CKP) Sensor Replacement (Sensor B)

REMOVAL PROCEDURE




1. Turn OFF the ignition.
2. Crank steering wheel fully to the left.
3. Raise the vehicle. Refer to Vehicle Lifting.
4. Remove the right tire and wheel.
5. Disconnect the crankshaft position (CKP) sensor electrical connector.
6. Remove the attaching bolt/screw.
7. Remove the CKP sensor from the engine.
8. Inspect for wear, cracks, or leakage if the CKP sensor is not being replaced.

INSTALLATION PROCEDURE
1. Lubricate the O-ring with clean engine oil before installation and replace if damaged.




2. Install the CKP sensor to the block.
3. Install the sensor attaching bolt.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten
Tighten the bolt to 11 N.m (97 lb in).

4. Connect the CKP sensor electrical connector.
5. Install the right tire and wheel.
6. Lower the vehicle.
7. Perform the CKP system variation learn procedure. Programming and Relearning
pro multis · About Operation CHARM