Multifunction, Turn Signal Switch

Multifunction, Turn Signal Switch Replacement

Removal Procedure





1. Remove the upper and lower steering column trim covers.





2. Remove the wire harness straps (2) from the steering column tilt head assembly (1) and the column.





3. Remove the wire harness assembly (1) from the wire harness strap (2).





4. Remove the 2 pan head tapping screws (1).





5. Remove the multifunction turn signal switch assembly (1).

Installation Procedure

Important: The electrical contact must rest on the turn signal cancel cam assembly.





1. Install the multifunction turn signal switch assembly (1) to the steering column assembly.

Notice: Refer to Fastener Notice in Service Precautions.





2. Install the 2 pan head tapping screws (1).
Tighten the screws to 7 Nm (62 inch lbs.).





3. Route the wire harness assembly along the steering column jacket assembly.





4. Install the wire harness assembly (1) into the wire harness strap (2).





5. Install new wire harness straps (2) to the steering column assembly (1) and the column.





6. Install the upper and lower steering column trim covers.