Starter Motor: Service and Repair
STARTER MOTOR REPLACEMENTREMOVAL PROCEDURE
CAUTION: Refer to Battery Disconnect Caution in Service Precautions.
1. Disconnect the negative battery cable.
2. Raise and suitably support the vehicle. Refer to Vehicle Lifting.
3. Remove the positive cable nut.
4. Remove the positive cable from the starter solenoid.
5. Remove the engine harness ground nut from the starter solenoid.
6. Remove the engine harness ground (4) from the starter solenoid.
7. Remove the starter motor bolts.
8. Remove the starter motor.
9. Remove the starter heat shield bolts, nut, and shield, if necessary.
INSTALLATION PROCEDURE
NOTE: Refer to Fastener Notice in Service Precautions.
1. Install the starter heat shield, nut and bolts, if necessary.
Tighten
- Tighten the bolts to 3 N.m (35 lb in).
- Tighten the nut to 5 N.m (44 lb in).
1. Install the starter motor.
2. Install the starter motor bolts.
Tighten
Tighten the bolts to 50 N.m (37 lb ft).
3. Install the engine harness ground (4) to the starter solenoid.
4. Install the starter solenoid nut.
Tighten
Tighten the nut to 3.4 N.m (30 lb in).
5. Install the positive cable to the starter solenoid.
6. Install the starter lead nut.
Tighten
Tighten the nut to 9 N.m (80 lb in).
7. Lower the vehicle.
8. Connect the negative battery cable.