2. Draining Fluids and Oil Filter Removal

Draining Fluids and Oil Filter Removal





1. Remove the oil filter cap. Remove the oil pan drain plug and allow the oil to drain out.
2. Remove the oil filter from the cap and discard.
3. Clean the oil filter housing in the engine block.

4. Notice: Refer to Fastener Notice in Service Precautions.

Install the oil pan drain plug.
^ Tighten the oil pan drain plug to 25 Nm (18 ft. lbs.).
5. Remove the water pump drain plug from the water pump and allow the coolant to drain from the water pump.
6. Apply sealant P/N 21485278 to the water pump drain plug.
7. Install the water pump drain plug.
^ Tighten the water pump drain plug to 20 Nm (15 ft. lbs.).
8. If cleaning or repairing the engine block, it is not necessary to reinstall the plugs.