OnStar Button LED Inoperative

OnStar Button LED Inoperative

Diagnostic Fault Information

Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. Initial Inspection and Diagnostic Overview

Circuit/System Description

The vehicle communication interface module (VCIM) is a 3-watt cellular device that allows the user to communicate data and voice signals over the national cellular network. It is powered by a fused, battery positive, voltage circuit connected through the vehicle wiring to the 3-button assembly and the radio, and attached by means of coax cables to the cellular and navigation antennas. Ground for the module is accomplished by means of dedicated circuits that are routed with body wiring systems to chassis ground points. The module houses 2 modems, one to process global positioning system (GPS) data, and the other for cellular information. Satellites orbiting earth are constantly transmitting signals of their current location, from which the OnStar(R) system is able to pinpoint its own location. The navigation antenna receives these GPS signals and provides the data to the VCIM to be processed. The VCIM communicates with the rest of the vehicle over the class 2 or GMLAN serial data bus, depending upon the serial data architecture of the vehicle. The ignition state is determined by the VCIM through class 2 or GMLAN messaging. The module also has the capability of commanding the horn, initiating door lock/unlock and operating the exterior lamps using the serial data circuits. When an OnStar(R) keypress is made, a serial data message is sent to the audio system to mute all radio functions and transmit OnStar(R) originated audio. After the audio system is muted, the OnStar(R) signals are transmitted to the audio system on the cellular telephone voice signal circuit, and returned to the module on the cellular telephone voice low reference circuit. The cellular modem connects the OnStar(R) system to the cellular carriers communication system by interacting with the national cellular infrastructure. The module sends and receives all cellular communications over the cellular antenna and cellular antenna coax.

Circuit/System Verification

Important: This procedure is for diagnosing problems with the OnStar(R) button assembly LED.

Ignition ON, verify that the OnStar(R) status LED does not turn green.

If it turns green, go to Testing for Intermittent Conditions and Poor Connections. Component Tests and General Diagnostics

Circuit/System Testing

1. Ignition OFF, disconnect the harness connector at the inside rearview mirror.
2. Ignition ON, test for 6.8-7.2 volts between the inoperative keypad LED signal, terminal 3 green or terminal 2 red and ground.

• If less than the specified value, test the green/red LED for an open/high resistance, or a short to ground. If circuit tests normal, test or replace the VCIM.

• If greater than the specified value, test the green/red LED for a short to voltage. If circuit tests normal, test or replace the VCIM and the inside rearview mirror.

3. If all circuits test normal, test or replace the inside rearview mirror.

Repair Instructions

Perform the Diagnostic Repair Verification after completing the diagnostic procedure. Verification Tests

* Control Module References for VCIM replacement, setup, and programming.
* Rearview Mirror Replacement