Rear Suspension

Wheel Bearing/Hub Replacement - Rear

Removal Procedure

Important: The wheel bearing in the rear wheel hub is integrated into one unit. The hub is non-serviceable. If the hub and/or bearing is damaged, replace the complete hub and bearing assembly.

1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle.
2. Remove the tires and wheels.
3. Remove the brake rotor.

Rear Wheel Speed Sensors:

4. Remove the ABS electrical connector from the wheel speed sensor (1), if equipped.
5. Remove the park brake cable from the park brake actuator.
6. Remove the mounting bolts from the rear bearing/hub.




7. Remove the wheel bearing/hub and park brake assembly from the knuckle.
8. Remove the park brake actuator from the rear wheel bearing/hub.

Installation Procedure




1. Install the park brake actuator to the rear wheel bearing/hub.
2. Install the wheel bearing/hub and park brake assembly to the knuckle.

Notice: Refer to Fastener Notice.

3. Install the wheel bearing/hub-to-knuckle bolts.

Tighten the bolts to 75 N.m (55 lb ft).

4. Install the park brake cable to the park brake actuator.

Rear Wheel Speed Sensors:

5. Install the ABS electrical connector to the wheel speed sensor (1), if equipped.
6. Install the brake rotor.
7. Install the tires and wheels.
8. Lower the vehicle.