Ignition Lock Cylinder Replacement

Ignition Lock Cylinder Replacement

Removal Procedure

Caution: Refer to SIR Caution.

1. Disable the SIR system. Refer to SIR Disabling and Enabling.
2. Remove the knee bolster.
3. Remove the steering column shroud.
4. With the key installed hold it in the START position.




5. Install an allen wrench into the hole on top of the ignition lock cylinder case.
Push down on the allen wrench to release the tab on the ignition lock cylinder inside the ignition lock cylinder case.




6. Slide the ignition lock cylinder out of the ignition lock cylinder case.

Installation Procedure






Important: The gears between the ignition/start switch and the ignition lock cylinder case must be in the correct position. Failure to do so will cause a misalignment of the gears in the ignition/start switch and the ignition lock cylinder case, which may result in a NO START or BATTERY DRAIN.

1. Use a screwdriver to rotate the ignition lock cylinder case gear clockwise to the start position - allowing it to spring return into the RUN position.




2. Install the key into the ignition lock cylinder.
3. Align the ignition lock cylinder and install it into the ignition lock cylinder case.
4. Install the steering column shroud.
5. Install the knee bolster.
6. Enable the SIR system. Refer to SIR Disabling and Enabling.