Front Axle Will Not Engage

Front Axle Will Not Engage

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. Initial Inspection and Diagnostic Overview
* Review Strategy Based Diagnosis for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions provides an overview of each diagnostic category.

Circuit/System Description

The front axle control circuit consists of an electric motor actuator which engages and disengages the front axle. The front axle actuator motor consists of a permanent magnetic motor, a worm gear controlled plunger, a front axle switch and an electronic control circuit within the actuator assembly.

The front axle actuator consists of the following circuits:

* The front axle control circuit, which is also connected to the transfer case shift control module
* The front axle switch circuit, which is also connected to the transfer case shift control module
* An ignition 3 voltage circuit
* A ground circuit

When a shift to 4HI, or 4LO is requested, the transfer case shift control module engages the front axle by grounding the front axle control circuit through a current limiting driver.

Circuit/System Testing

1. If this is occurring without DTC C0379 setting it is likely related to a mechanical issue. Refer to Four-Wheel Drive Does Not Engage. Four-Wheel Drive Does Not Engage
2. If no mechanical issue is found replace the front axle actuator.

Repair Instructions

Perform the Diagnostic Repair Verification after completing the diagnostic procedure. Verification Tests

* Control Module References for TCSCM replacement, setup, and programming
* Transfer Case High/Low Clutch Reset
* Four-Wheel Drive Does Not Engage
* Four-Wheel Drive Does Not Disengage
* Front Drive Axle Actuator Replacement