B3445

DTC B3445

DTC DESCRIPTOR

DTC B3445 00
Stop Lamp Circuit

DIAGNOSTIC FAULT INFORMATION




Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. Initial Inspection and Diagnostic Overview

CIRCUIT/SYSTEM DESCRIPTION
When the brake pedal is applied, the brake pedal switch normally closed contact signal circuit voltage is interrupted to the body control module (BCM). The BCM then applies a voltage to the stop lamp supply voltage circuit to the stop lamps.

CONDITIONS FOR RUNNING THE DTC
- The ignition is ON.
- The stop lamps must be commanded ON.

CONDITIONS FOR SETTING THE DTC
The BCM detects a short to ground in the stop lamp supply voltage circuit when the stop lamps are commanded ON.

ACTION TAKEN WHEN THE DTC SETS
The stop lamps do not illuminate.

CONDITIONS FOR CLEARING THE DTC
- The conditions for setting the DTC are no longer present.
- A history DTC clears after 100 malfunction-free ignition cycles.
- The BCM receives the clear code command from the scan tool.

CIRCUIT/SYSTEM VERIFICATION
Ignition ON, press the brake pedal. The stop lamps should illuminate.

CIRCUIT/SYSTEM TESTING
1. Disconnect the stop lamps and test the individual stop lamp assemblies for internal shorts between all terminals.
- If a short between terminals is found, replace the stop lamp socket or circuit board as applicable.
2. Test the stop lamp supply voltage circuit for a short to ground.
- If all circuits/connections test normal, replace the BCM.

REPAIR INSTRUCTIONS
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
- Tail Lamp Bulb Replacement (Cadillac) Tail Lamp Bulb Replacement (Tahoe, Avalanche) Tail Lamp Bulb Replacement (Yukon)
- Control Module References for BCM replacement, setup, and programming. Verification Tests Programming and Relearning