Upper Control Arm Replacement

Upper Control Arm Replacement

Removal Procedure




1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
2. Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation.
3. Remove and discard the upper ball joint to upper control arm pinch bolt and nut.
4. Disconnect the upper control arm from the steering knuckle.




5. Disconnect the ABS wheel speed sensor wiring harness from the upper control arm.
6. If removing the left side, remove the battery tray. Refer to Battery Tray Replacement.




7. Gently pry out on inner fender body panel to access forward facing bolt.




8. Remove the upper control arm mounting bolts.
9. Remove the upper control arm.

Installation Procedure




1. Install the upper control arm.




2. Gently pry out on inner fender to access the forward facing bolt.

Notice: Refer to Fastener Notice.

3. Install the upper control arm mounting bolts.

Tighten the upper control arm mounting bolts to 150 N.m (111 lb ft).

4. Install the battery tray, if removed. Refer to Battery Tray Replacement.




5. Connect the ABS wheel speed sensor wiring harness to the upper control arm.




6. Connect the upper control arm to the steering knuckle.
7. Install a new upper ball joint to upper control arm pinch bolt and nut.

Tighten the upper ball joint to upper control arm pinch bolt to 40 N.m (30 lb ft).

8. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation.
9. Lower the vehicle.
10. Check the front wheel alignment. Refer to Wheel Alignment Specifications.