C0242

DTC C0242

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions provides an overview of each diagnostic category.



DTC Descriptor
DTC C0242 00
- Engine Control Module (ECM) Indicated TCS Malfunction

DTC P0856
- Engine Control Module (ECM) Indicated TCS Malfunction




Circuit/System Description

The electronic brake control module (EBCM) and the engine control module (ECM) simultaneously control the traction control. The EBCM sends a serial data message to the ECM requesting torque reduction. When certain ECM DTCs are set, the ECM will not be able to perform the torque reduction for traction control. A serial data message is sent to the EBCM indicating that traction control is not allowed.


Conditions for Running the DTC

* The ignition is ON.
* Ignition voltage is greater than 8 volts.



Conditions for Setting the DTC

The ECM diagnoses a condition preventing the engine control portion of the traction control function and sends a serial data message to the EBCM indicating that torque reduction is not allowed. The ECM will typically set a DTC and the EBCM will set this DTC.


Action Taken When the DTC Sets

* The EBCM disables the TCS for the duration of the ignition cycle.
* The Traction Off indicator turns ON.
* The DIC displays the Service Traction Control message.
* The ABS remains functional.



Conditions for Clearing the DTC

* The condition for the DTC is no longer present and the DTC is cleared with a scan tool.
* The electronic brake control module (EBCM) automatically clears the history DTC when a current DTC is not detected in 100 consecutive drive cycles.



Reference Information
Schematic Reference

Antilock Brake System Schematics (Electrical Diagrams)
Connector End View Reference

Component Connector End Views
Description and Operation

ABS Description and Operation (With JL4) (ABS Description and Operation (With RPO JL4))ABS Description and Operation (Without JL4) (ABS Description and Operation (Without RPO JL4))
Electrical Information Reference

* Circuit Testing
* Connector Repairs
* Testing for Intermittent Conditions and Poor Connections
* Wiring Repairs

Scan Tool Reference

Control Module References for Scan Tool Information


Circuit/System Verification

Verify that no DTCs are set in the ECM.

If DTCs are set, refer to Symptoms - Engine Controls .



Repair Instructions

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.


Control Module References