Headlamp Switch: Service and Repair

Headlamp Switch Replacement

Removal Procedure

1. Remove the knee bolster trim panel. Refer to Driver Knee Bolster Panel Replacement (Service and Repair).




2. Remove the screw retaining the switch to the instrument panel (I/P).
3. Partially remove the switch from the I/P.
4. Disconnect the switch electrical connector.
5. Remove the switch from the vehicle.

Installation Procedure




1. Position the switch to the I/P.
2. Connect the electrical connector to the switch.
3. Install the switch to the I/P.

Caution: Refer to Fastener Caution (Fastener Caution).

4. Install the screw retaining the switch to the I/P.

Tighten the screw to 2.5 Nm (22 lb in).

5. Install the knee bolster trim panel. Refer to Driver Knee Bolster Panel Replacement (Service and Repair).