Shift Interlock Solenoid: Service and Repair

Automatic Transmission Shift Lock Control Actuator Replacement

Removal Procedure




1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (RPO LS4) (Service and Repair)Battery Negative Cable Disconnection and Connection (RPOs LZE/LZ4/LZ8) (Service and Repair).

Caution: To prevent component damage, DO NOT use metal tools to remove the trim.

Note: Use only a plastic trim tool to lift the shift lever bezel or trim plate. Do not use any tool between the shift lever bezel or trim plate and the shifter.

2. Remove the center console. Refer to Front Floor Console Replacement (Service and Repair).
3. Disconnect the automatic transaxle shift lock actuator electrical connector (1).
4. Remove both ends of the automatic transaxle shift lock actuator from the pivot points.

Installation Procedure




1. Install both ends of the automatic transaxle shift lock actuator to the pivot points.
2. Connect the automatic transaxle shift lock actuator electrical connector (1).
3. Install the center console. Refer to Front Floor Console Replacement (Service and Repair).
4. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (RPO LS4) (Service and Repair)Battery Negative Cable Disconnection and Connection (RPOs LZE/LZ4/LZ8) (Service and Repair).