Cylinder Head Assembly

CYLINDER HEAD




Cylinder Head Bolt
First Pass 30 Nm (22 lb ft)
Final Pass 155 degrees

CYLINDER HEAD BOLT RE-USABILITY

Notice: DO NOT allow oil on the cylinder head bolt bosses. DO NOT reuse the old cylinder head bolts.

CYLINDER HEAD

Surface Flatness - Block Deck
Longitude 0.050 mm (0.002 in)
Overall 0.1 mm (0.004 in)
Transverse 0.030 mm (0.0012 in)

CYLINDER BLOCK

Cylinder Head Deck Surface Flatness
Longitude 0.050 mm (0.002 in)
Overall 0.08 mm (0.0031 in)
Transverse 0.030 mm (0.0012 in)

INTAKE MANIFOLD




Intake Manifold to Cylinder Head Bolt/Nut 10 Nm (89 lb in)

CAMSHAFT BEARING CAP
Tighten the camshaft cap bolts in increments of 3 turns until they are seated.
Camshaft Cap Bolt 10 Nm (89 lb in)

EXHAUST MANIFOLD




Exhaust Manifold to Cylinder Head Nut - 2 passes 14 Nm (124 lb in)