Electronic Brake Control Module Replacement (With JL4)

Electronic Brake Control Module Replacement (With JL4)

Removal Procedure

Caution: Always connect or disconnect the wiring harness connector from the EBCM/EBTCM with the ignition switch in the OFF position. Failure to observe this precaution could result in damage to the EBCM/EBTCM.




1. Turn the ignition switch to the OFF position.
2. Remove the cover from the engine control module (ECM) and transmission control module (TCM).
3. Clean the electronic brake control module (EBCM) to brake pressure modulator valve (BPMV) area of any accumulated dirt and foreign material.
4. Disconnect the electrical connector from the EBCM.
5. Remove the EBCM bolts (1).




6. Separate the EBCM (1) from the BPMV by carefully pulling apart.
Do not pry the components apart.




7. Remove the 12 EBCM O-ring seals (1).
8. If installing a new EBCM, discard the O-ring seals.

Installation Procedure




1. Install the 12 EBCM O-ring seals (1).
2. If installing a new EBCM, install new O-ring seals.




3. Carefully install the EBCM (1) to the BPMV.





Caution: Refer to Fastener Caution (Fastener Caution).

4. Install the EBCM bolts (1).

Tighten the bolts to 3 Nm (27 lb in).

5. Connect the electrical connector to the EBCM.
6. Install the cover to the ECM and TCM.
7. If a new EBCM is being installed, program the EBCM. Refer to Electronic Brake Control Module Programming and Setup (Testing and Inspection).
8. Refer to Control Module References (Programming and Relearning) for programming and setup information.