Turn Signal Switch Housing Replacement

Turn Signal Switch Housing Replacement

Removal Procedure

1. Remove the turn signal cancel cam and steering shaft upper bearing spring. Refer to Turn Signal Cancel Cam and Steering Shaft Upper Bearing Spring Replacement (Turn Signal Cancel Cam and Steering Shaft Upper Bearing Spring Replacement).
2. Remove the turn signal multifunction switch. Refer to Turn Signal Multifunction Switch Replacement (Turn Signal Multifunction Switch Replacement).




3. Slide the turn signal switch housing off of the steering column.

Installation Procedure





Note: The turn signal switch housing must be pressed firmly against the steering column to seat it properly.

1. Slide the turn signal switch housing onto the steering column.
2. Install the turn signal multifunction switch. Refer to Turn Signal Multifunction Switch Replacement (Turn Signal Multifunction Switch Replacement).
3. Install the turn signal cancel cam and steering shaft upper bearing spring. Refer to Turn Signal Cancel Cam and Steering Shaft Upper Bearing Spring Replacement (Turn Signal Cancel Cam and Steering Shaft Upper Bearing Spring Replacement).