Replacing Keys (Canada)

Replacing Keys (Canada)

10-Minute Vehicle Key Relearn

Important:
This procedure will only relearn the vehicle keys. This procedure will not learn the immobilizer prerelease password or the challenge/response data. Do not use this procedure as a substitute for a 10-minute relearn when replacing or reprogramming a theft deterrent module (TDM) or engine control module (ECM). Doing so will result in a failure to learn the pre-release password and/or the challenge/response data.


This 10-minute learn procedure should be used when all vehicle keys are desired to be replaced or reprogrammed. This procedure will erase all previously learned vehicle keys from the TDM. Once the 10-minute learn procedure has been completed, any remaining vehicle keys may be programmed using the Adding Keys procedure to ensure their continued functionality.

1. Connect a scan tool to the vehicle in the pass-thru arrangement.

2. Turn ON the ignition, with the engine OFF.

3. Ensure that all power consuming devices are turned OFF on the vehicle.

4. On the Techline Terminal, select Service Programming System and follow the Techline Terminal on-screen instructions, using the Pass-Thru method. Ensure the correct programming selection is chosen based on component being replaced or programmed. For this procedure, go to the VTD Vehicle Theft Deterrent Learn menu and choose the Vehicle Theft Deterrent Learn for Learning Replacement Keys selection.

5. At this point the scan tool must remain connected for the duration of the 10-minute relearn procedure.

Important:

* The scan tool will initially display 12 Minutes. The first 2 minutes allow the scan tool to initialize the appropriate control module. The remaining 10 minutes is the relearn timer.


* On some vehicles the security indicator may be illuminated for the duration of the 10-minute relearn procedure.


6. Observe the scan tool, after approximately 10 minutes the scan tool will display "Programming Successful, Turn OFF Ignition". The vehicle is now ready to relearn the key information and/or the passwords on the next ignition switch transition from OFF to RUN.

7. Turn OFF the ignition and wait 2 minutes.

8. With a master vehicle key, turn the ignition to the RUN position for 15 seconds, then start the vehicle. The TDM has now learned the key transponder information.

9. With a scan tool, clear any DTCs.

10. If the key being learned is a new vehicle key, the keyless entry transmitter portion of the key must also be learned. Refer to Remote Control Door Lock Transmitter Learn Testing and Inspection.