5. Clutch Pilot Bearing Removal

Clutch Pilot Bearing Removal

Special Tools

* J 2619-01 - Slide Hammer

* J 23907 - Slide Hammer with Bearing Adapter

* J 23907-1 - Slide Hammer

For equivalent regional tools, refer to Special Tools Special Tools.





Note:
J 23907-1 - slide hammer was part of the J 23907 - slide hammer with bearing adapter set. The adapter is still available as J 23907 - adapter.

1. Remove the clutch pilot bearing using the J 23907 - adapter (1) and J 23907-1 - slide hammer (2).

1. Install the legs of the J 23907 - adapter (1) into the clutch pilot bearing.

2. Rotate the shaft of the tool until the legs of the tool are snug and contacting the I.D. surface of the bearing.

3. Install the J 23907-1 - slide hammer (2) to the J 23907 - adapter (1).

4. Remove the bearing from the rear of the crankshaft.

5. Remove the special tools from the bearing.





2. Discard the bearing.