95. Engine Flywheel Installation

Engine Flywheel Installation (LDE, LED, LFJ, LXV, 2H0, LUW)

Special Tools
* EN-652 - Flywheel Holder
* EN-45059 - Torque Angle Sensor Kit

For equivalent regional tools, refer to Special Tools Special Tools.

1. Clean the thread in the crankshaft.




2. Install the flywheel (2).
3. Install the EN-652 - holder (1).





Caution: Refer to Fastener Caution Fastener Caution.

Caution: Refer to Torque-to-Yield Fastener Caution Torque-to-Yield Fastener Caution.

4. Install the 6 NEW flywheel bolts (1, 2) and tighten the bolts in 3 passes using the EN-45059 - sensor kit :

1. First pass to 35 Nm (26 lb ft).
2. Second pass to additional 30°.
3. Third pass to an additional 15°.

5. Remove the EN-652 - holder.