Rear Axle Lubricant Level Inspection (10.5 Inch Axle)

Rear Axle Lubricant Level Inspection (10.5 Inch Axle)

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle Service and Repair.

2. Make sure the vehicle is level.

3. Clean the area around the rear axle fill plug.





Note:
If any lubricant leaks are found, repair the leaks as needed.

4. Remove the rear axle fill plug 1 and inspect the lubricant level.

5. The lubricant level should be between 0-10 mm (0-0.4 in)below the fill plug opening.

6. If the level is low, add lubricant until the level is even with the bottom edge of the fill plug opening. Use the proper fluid. Refer to Fluid and Lubricant Recommendations Maintenance.

Caution:
Refer to Fastener Caution Fastener Caution.

7. Install the rear axle fill plug 1 and tighten to 33 Nm (24 lb ft).

8. Remove the support and lower the vehicle.