Engine Flywheel Installation

Engine Flywheel Installation

Special Tools

* EN-652 - Flywheel Holder

* EN-45059 - Torque Angle Sensor Kit

For equivalent regional tools, refer to Special Tools Special Tools.




1. Install the crankshaft position reluctor ring (1).




2. Install the flywheel (2).

3. Install the EN-652 - holder (1).





Caution: Refer to Fastener Caution Fastener Caution.

Caution: Refer to Torque-to-Yield Fastener Caution Torque-to-Yield Fastener Caution.

4. Install the 6 NEW flywheel bolts (1, 2) and tighten the bolts in 3 passes using the EN-45059 - sensor kit:

1. First pass to 60 Nm (44 lb ft).

2. Second pass to additional 45°.

3. Third pass to an additional 15°.

5. Remove the EN-652 - holder.