Engine Flywheel Installation

Engine Flywheel Installation

Special Tools

* EN-470-B - Angular Torque Wrench

* EN-652 - Flywheel Holder

For equivalent regional tools, refer to Special Tools Tools and Equipment.




1. Install the engine flywheel (1).

2. Install the 6 NEW engine flywheel bolts (2).




3. Install EN-652 - holder (1) to hold the engine flywheel (2).

Caution: Refer to Fastener Caution Fastener Caution.

Caution: Refer to Torque-to-Yield Fastener Caution Torque-to-Yield Fastener Caution.

4. Tighten the 6 engine flywheel bolts in a cross sequence to 60 Nm (44 lb ft).

1. Tighten the 6 engine flywheel bolts in a cross sequence to an additional 45 degrees. Use EN-470-B - wrench.

2. Tighten the 6 engine flywheel bolts in a cross sequence to an additional 15 degrees. Use EN-470-B - wrench.

5. Remove EN-652 - holder.