Timing Belt Inspection

Timing Belt Inspection

Special Tools

* EN-6340 - Locking Tool

* EN-6628-A - Locking Tool

For equivalent regional tools, refer to Special Tools Special Tools.

Removal Procedure

1. Remove the timing belt upper front cover. Refer to Timing Belt Upper Front Cover Removal Service and Repair.





2. Set the crankshaft balancer in the direction of the engine rotation to "1st cylinder TDC" (mark 1).

3. Remove the camshaft cover. Refer to Camshaft Cover Removal Service and Repair.





Note:
The right half of the EN-6340 - locking tool can be recognized by the lettering "right", arrow, on the tool.

4. Prepare the right half of the EN-6340 - locking tool.

1. Remove the 2 bolts (2).

2. Remove the front panel (1) from the EN-6340 - locking tool -right.





Note:

* The spot type marking (4) on the intake camshaft position actuator adjuster does not correspond to the groove of the EN-6340 - locking tool - left (1) during this process, but must be somewhat above.

* The spot type marking (3) on the exhaust camshaft position actuator adjuster must correspond to the groove on EN-6340 - locking tool - right (2).

5. Insert the EN-6340 - locking tool - left (1) and the EN-6340 - locking tool - right (2) in the camshaft position actuator adjuster.





Note:
If the EN-6628-A - locking tool cannot be inserted, the timing must be set.

6. Align the camshafts horizontally by the hexagon (arrows) until the EN-6628-A - locking tool can be inserted in both camshafts.





7. Insert the EN-6628-A - locking tool (1) into the camshafts.

Installation Procedure

1. Remove the EN-6628-A - locking tool.

2. Remove the EN-6340 - locking tool.

3. Install the camshaft cover. Refer to Camshaft Cover Installation Service and Repair.

4. Install the timing belt upper front cover. Refer to Timing Belt Upper Front Cover Installation Service and Repair.