Operation CHARM: Car repair manuals for everyone.
Home >> Chevrolet >> 2013 >> Volt L4-1.4L Elect >> Repair and Diagnosis >> Hybrid Drive Systems >> Service and Repair >> Removal and Replacement >> Drive Motor Generator Control Module Coolant Pump Hose Replacement
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Drive Motor Generator Control Module Coolant Pump Hose Replacement




Drive Motor Generator Control Module Coolant Pump Hose Replacement

Special Tools

BO-38185 - Hose Clamp Pliers

For equivalent regional tools, Refer to Special Tools Tools and Equipment

Removal Procedure

Note:
Replace corroded hose clamps and brackets.

1. Remove the front wheelhouse front liner on the driver side. Refer to Front Wheelhouse Front Liner Replacement





2. Place a drain pan under pump.

3. Remove the drive motor generator control module coolant pump hose clamp (1) at generator control module coolant pump using BO-38185 - Hose Clamp Pliers.

4. Remove the drive motor generator control module coolant pump hose (2) from the generator control module coolant pump.





5. Remove the drive motor generator control module coolant pump hose clamp (1) at drive motor battery coolant air separator using BO-38185 - Hose Clamp Pliers.

6. Remove the drive motor generator control module coolant pump hose (2) from drive motor battery coolant air separator.

7. Remove the drive motor generator control module coolant pump hose from the vehicle.

Installation Procedure





1. Install the drive motor generator control module coolant pump hose to the vehicle.

2. Install the drive motor generator control module coolant pump hose (2) to the drive motor battery coolant air separator.

3. Install the drive motor generator control module coolant pump hose clamp (1) at drive motor battery coolant air separator using BO-38185 - Hose Clamp Pliers.





4. Install the drive motor generator control module coolant pump hose (2) to the generator control module coolant pump.

5. Install the drive motor generator control module coolant pump hose clamp (1) at generator control module coolant pump using BO-38185 - Hose Clamp Pliers.

6. Install the front wheelhouse front liner on the driver and passenger side. Refer to Front Wheelhouse Front Liner Replacement

7. Remove the drain pan.

8. Fill the cooling system.

pro multis · About Operation CHARM