Clutch Coil & Pulley Rim, V Groove Type

REMOVAL

1. Remove clutch rotor and bearing assembly as outlined previously. However, do not remove from compressor front head.
2. Remove pulley rim mounting screws and slide rim from rotor and hub assembly.
3. Replace pulley rim or clutch coil as necessary.

INSTALLATION

1. Assemble clutch coil, pulley rim and rotor and bearing assembly. Then place on neck of front head and seat into position with tool J-25029. Ensure clutch coil terminals are positioned properly and three protrusions on rear of clutch coil align with front head locator holes.
2. Install rotor and bearing assembly, retaining snap ring, then assemble clutch plate and hub assembly. Check clearance between clutch plate and rotor to be .020-.040".
3. Install and torque pulley rim mounting screws to 100 inch lbs.