Disassembly

1. Remove snap ring (619) and direct clutch driving hub from forward clutch housing.

2. Remove forward clutch hub and thrust washers.

3. Remove clutch plates, then the waved or dished plate.

4. Remove apply ring, if equipped.

5. Using spring compressor tool No J-23327-1 and adaptor tool No. J-2501 8-A, or equivalents, remove snap ring and release spring assembly.

6. Remove piston release spring and piston.

7. Remove turbine shaft as follows. Unless forward clutch housing and/or turbine shaft is damage disassembly is not necessary.

a. Place housing in mechanical press with turbine shaft down.

b. Remove turbine shaft by placing 3/8 inch drive extension on end of shaft and pressing out.